Common repairs to coffee makers include servicing the on/off switch, thermostat, heating element, and warming element.
Servicing an On/Off Switch: A coffee maker's switch is a simple device that controls current to the heating unit and pump. Fortunately, this key controller is easy to test and to replace. Here's how: Step 1: Make sure the coffee maker is unplugged. Step 2: Remove the base or shell to access the back of the switch. Step 3: Place test probes across the terminals and activate the switch. The circuit should be closed and show continuity as indicated by the switch positions. The same test of continuity can be used to test other controllers, such as timers. All operate as switches, conducting electricity in some settings and not in others. Servicing a Drip Coffee Maker's Thermostat: A thermostat in a drip coffee maker controls electricity to operate the heating element. It can cause problems if it doesn't work correctly. To test the thermostat in a drip coffee maker: Step 1: Unplug the unit, empty excess water from the reservoir, turn the unit over, and remove the base. (Special head screwdrivers -- available at larger hardware stores -- may be required.) Step 2: Use a continuity tester or multitester to check the thermostat, placing a probe at each end. Step 3: If defective, remove and replace the thermostat with one of the same rating. Step 4: Also check the continuity of the fuse and replace it if the circuit is open. Servicing a Percolator Coffee Maker's Thermostat: The thermostat in a percolator coffee maker serves the same function, but looks different from one in a drip system. To test a percolator coffee maker's thermostat: Step 1: Unplug the coffee maker, make sure the coffee and filter are removed before turning it over, then remove the base to expose the heating element and thermostat. Step 2: Test the thermostat's continuity. Step 3: If the thermostat is an open circuit, replace it. If replacing the thermostat requires unriveting or desoldering it, consider taking it to an appliance-repair shop or replacing the entire coffee maker. Servicing Heating Elements: A coffee maker's heating element is a critical component. No one wants cold coffee. The heating element in either a drip or percolator coffee maker is accessed through the base of the appliance. To test and replace a heating element: Step 1: Make sure all liquids and grounds are emptied from the appliance before turning it over to remove the base. Step 2: Once accessed, the heating element can be tested using a continuity tester or a multitester as you would any conductor. Disconnect the unit from the circuit, then place a probe at each terminal and verify that the element can conduct electricity. Step 3: If no electricity is being conducted, replace the heating element unit or assembly. With masking tape, mark the location of all wires and components you loosen so you will be able to reconnect them with ease. Servicing Warming Elements: Once the coffee is brewed, the warming element in the base of the coffee maker keeps it warm. The warming element on some coffee makers remains on all day long, so it may be the first component to fail. In addition, water or brewed coffee may spill and leak into the warming element, shorting it out. Here's how to test and replace a warming element: Step 1: Remove the coffee maker's base, identify the warming element, and disconnect it from the terminals. Step 2: Check for continuity using a continuity tester or multitester. Step 3: Replace the warming element, if necessary.
0 Comments
|